4 Ton Air/Hydraulic Single Post Lift

• This machine adopts the American pneumatic hydraulic drive design. It does not require power supply to drive directly. It can be used as long as it is connected to an air compressor with an air pressure of 5-8 bar. The maximum lifting weight is 4000kg.

• The safety insurance relies on the 155 liters of hydraulic oil in the lift cylinder to support it. Even if there is a leak, the hydraulic oil flow in the cylinder will automatically control the descent speed. The descent speed will not be less than 50 seconds. As long as the lift is in working condition, the built-in safety insurance will always be in working condition at any height.

• This machine uses high-strength and sturdy seamless steel pipes. After anti-corrosion treatment, it can be installed outdoors. It is not afraid of water and can be used normally even in the case of immersion. It is especially suitable for car washing and beauty industry.

• Since this machine is gas-driven, the whole machine has no electronics, so the failure rate and maintenance rate are very low, and there will be no situation where the vehicle cannot be lowered during a power outage.

• During operation, the lifting height of this machine can be adjusted according to the needs of work according to the actual needs of the operator.