Getting Started:
Plug in control box and turn on. Carefully insert desired staple into one of three possible positions in the end of the stapler without depressing the power button on the handle. Once pressed to the bottom of the hole, the unit is ready for use.

Setting the Temperature:
Turn the control dial to the second or third position, unless very low heat levels are desired. These two positions satisfy most stapling applications.
Use:
Lay staple over the desired location and apply gentle pressure. Push the button on the handle, then release once the staple is at the desired depth. Allow to cool slightly. Pull back and the staple will remain in the plastic. Clip off the staple with the supplied diagonal cutter.

Caution:

When clipping off the staple prongs, wear eye protection and cup your hand over the staple to prevent the clipped wire from becoming a projectile.

Output voltage: 0.8-1.6V

Input current: 0.3-0.7A

Output current: 20-60A

Packing: Plastic box with carton

Size: 40*19*19cm

Gross weight: 5.5kg

Cable plug style can be ordered

Kit Contents:
* Controller and wand
* (100 pcs) - Rs16 0.6mm flat staples
* (100 pcs) - Rs18 0.8mm flat staples
* (100 pcs) - Rs26 0.6mm wave staples
* (100 pcs) - Rs28 0.8mm wave staples
* (100 pcs) - Rs38 0.8mm corner staples
* (100 pcs) - Rs46 0.6mm outside corner staples
* ( 1 pc) - diagonal cutter
* ( 1 pc) - storage box